Modern metal doors provide reliable protection against unauthorized penetration in houses or apartments. But like all products, they have a limit of strength, especially with intensive operation, locking devices can fail. If the castle stops working, then do not despair if you wish and the presence of straight hands can still be repaired and fully restored performance. There are cases when the keys are lost, then only one solution to the problem – replacing the entire locking mechanism. At first glance, it seems that replacing locks is a complex process that requires special training, but in fact everything can be done independently and without the use of outside help.
Today the call of the master to replace the locking devices of the doors of metal is quite expensive. At the same time, it can not always be caused promptly, and you will have to wait a lot of time. It should be remembered that they can be replaced with exactly the same, because modern steel doors make manufacturers specifically for a certain type of locking device with specific seats. Among other things, everything in the design is located individually, in particular accessories, valves and handles. To carry out the replacement of a leaf lock, you should completely push the crossbar of the locking mechanism to the end, so it will open. Next, the key is removed from the keyhole. Handles and valves are dismantled, overlays in this case are not necessary at all. After that, all end fasteners are twisted, as a rule, these are four self -tapping screws.
After that, it will be possible to get a mechanism by hooking for the end bar. Next, a similar castle is used, which in the same way is mounted in the design of the door only in the reverse order. It is best to purchase it from a company that made Torex steel doors, this will help to avoid unpleasant surprises. Among other things, you can save money and it will be more reliable. Когда в конструкции имеется функция перекодировки замка, то его менять совершенно не обязательно. In this case, it is enough to use a new set of keys and after which the locking device under them is transcoded. When the mechanism of the cylinder locking device works without problems, but the keys were lost, then it makes no sense to completely change it. In this case, it is enough to replace only the larva, which is much simpler and more convenient.
To replace the cylinder of the mechanism, you should unscrew the stop screw located on the end bar. Further, the key is placed in the keyboard on the inside, and the cylinder is removed. In separate models, in order to remove the cylinder, you need to use the key to turn it by twenty degrees and thus the dog will be in the dimensions of the cylinder. After that, you need to purchase the same cylinder on dimensions. Particular attention should be paid to the distance between the outer edge of the cylinder and the dog. Further, the cylinder returns to the same place in the steel doors and is fixed using the use of a stop screw. Quite often it is required to carry out the replacement of the case of the locking device, especially when the problem is not in the mechanism itself.
To do this, pushing the device’s crossbar, thus open the lock after that the cylinder is dismantled from the keyhole. The valve and armored overlays are removed, decorative elements do not need to be removed. After these manipulations, the lock can be pulled out by means of the end bar. Next, a similar locking device is mounted.
Get high -quality locks from the manufacturer, thereby you will save yourself from many troubles and breakdowns.